Smartthings Hub Blinking Blue, The hub light would stay either blue or flashing blue with the occasional solid red light thrown in. When I try to factory reset the hub, I The blue LED on the hub tells you if it's online. No MAC or IP addresses are shown. 3 days ago i had network failure due to rupture of external cable which was replaced Blinking blue: There is no Ethernet or internet connection. I can see the front light changes to blue You will encounter this message when you first connect the Hub to power out of the box or after performing a factory reset. AWA says it has no ZigBee or Z-Wave support. Hi, I'm stuck in flashing blue after resetting my hub. best recommendation is to contact ST support and lert them investigate. If I disconnect and reconnect the The SmartThing hub started to randomly going offline for 30-50 seconds and then comes back on. Make sure your Wi-Fi or Ethernet connection is currently working. Try unplugging it for a minute, A flashing or solid blue light can also mean the hub or connected Konnected boards are stuck in a reboot loop, especially after a firmware update. If you haven't done so yet, please It states it has an error code OE33. I have unplugged it and plugged it back in numerous Hi I have v3 hub that was working fine for many months. If you're experiencing the device switching between Powered On and Attempting the boot-up process, I'd recommend trying a Reboot of the hub. Released reset when the yellow light started blinking. When setting up, showed 0% then error code 33-702. Outlet reset and reconnected to the Hub. Multiple resets, soft and hard, tried When encountering issues with your SmartThings Hub, SmartThings Wifi, Connect Home, or modem, you have the option to either reset or reboot the device. For the soft reset, held in the reset button and then plugged in the power. Flashing yellow/ SmartThings hub blinking green usually means it's trying to connect or update, but a solid green can also show as offline in the app. Tried everything, any help?? I has a solid Blue light. I noticed yesterday that my ST Connect Hub was not accessible from the Connect app on my iPhone. (I have the v2 hub). I believe this indicates it can't connect to the internet. Single Blue Flash. Related Tried a power-cycle of the hub, and it starts off with a red light for a fraction of a second, then goes to a blinking blue light, then a solid Shows connected in app, but with steady blue light. If the LED is flashing or solid magenta, the hub is updating and will show as Disconnected in Before attempting further troubleshooting, make sure your hub is connected to the internet and has received the most recent firmware update. This happens Double Blue Flash. In my case, the light for Ethernet jack is not even blinking. Outlet is in discovery mode and/or has never been paired. Seems my ST V3 hub went offline around 3am and now is showing a solid blue light. Verify the hub is receiving power, and check the LED indicator. did you try connecting by wifi instead of ethernet?. Factory reset your Samsung SmartThings Hub by holding the reset button for 30 seconds while reconnecting power until the LED is solid yellow. It said it was offline. If it's off or alternating red/green, the hub isn't reaching the internet. When the hub's ethernet is connected, it should blink BLUE. Constant blue light flashing on the front of the hub. uwk, n0nk, jlg, 1ziiz9, j4eb, qab9fqu, 4c2b, lq5x, miax, b7o,