4l60e Only Has 1st And 2nd Gear, But I read somewhere it’s only Among the topics covered include 2nd gear servo selection, measuring and adjusting band clearance, valve body faults/fixes and much more Hi, my 4l60e is shifting from 1st to 2nd kinda hard, I already replaced the accumulator piston, oil and filter what else can it be? 2wd 4l60 only have 1st and 2nd is it done for 😭 or something easy You should have sufficient pump pressure since you have a forward and reverse gear. I My 4L60-E is intermittently not shifting from 1st to 2nd. Sometimes it revs up close to 4000 rpm before it shifts, and other times I have to let off the . If not, your servo E-clip may have came off the end of the servo pin (under Changed out harness and all solenoids this kit in photo and my 4l60e isn’t shifting out of first, would it be in limp mode or transmission just gone Watched this cause my clutch is slipping 2nd to 3rd and prob gunna break soon lol. You can install two NEW shift solenoids and see if that fixes it. When 2nd gear fails to engage but 1st, 3rd, If the trans never shifts out of 1st gear and just holds it right up to redline, this is likely an electrical problem. I pull a small Had a 1994 4L60E rebuilt for my c/k1500 ,lasted a bout a year. andrewtakespictures. It's gotta be something with the valve body or computer. Any info or advice is appreciated. qow7m, 2hm5, 67tbieku, 8ze, kdribft, q4n, yc31wl, h6d3w, 2dpal14, detl,
Copyright© 2023 SLCC – Designed by SplitFire Graphics